1. The aerial construction working platform should be equipped with safety ropes and safety locks for operators. The safety ropes should be fixed in the reliable position of the building and shall not be connected with any part of the hanging platform and shall meet the following requirements:1). the safety rope shall meet the requirements of the current national standard "safety belt" GB6095, and its diameter shall be consistent with the specification of the safety lock;2). the safety rope shall not be loose, broken or knotted;3). the parts of the safety lock shall be intact and complete, and the specification and direction mark shall be clear and distinguishable.
2. The hanging platform shall be equipped with a protective shed to prevent falling objects from high places from causing injuries to operators.
3. The working platform should be equipped with upper and lower limit device.
4. Obstacles affecting the normal operation of the hanging platform should be removed when using. In the area under the hanging platform that may cause injury of falling objects, a security isolation zone and warning sign shall be set up. Personnel and vehicles shall not stay or pass.
5. Operators shall wear tool bags for installation, maintenance and other operations in the hanging basket.
6. Overseas hanging basket equipment shall have Chinese operating instructions. The safety performance of products should meet the current standards of China.
7. The hanging platform shall not be used as a vertical transport equipment.
8. There should not be more than 2 operators in the hanging platform.
9. When the hanging platform works normally, the personnel shall enter the hanging platform from the ground, and shall not enter or leave from the top of the building, windows or other holes.
10. Operators should wear safety helmets, fasten safety belts, and properly hang the safety locks on independently set safety ropes.
11. Load balance shall be maintained inside the hanging platform. Overload operation is strictly prohibited.
12. When lifting the hanging platform, the height difference between the two ends of the working platform shall not exceed 150mm.
13. When using the hanging platform with centrifugal trigger safety lock to stay in the air, the safety lock should be locked on the safety rope. When starting the platform in the air, lift the hanging basket to relax the safety rope before opening the safety lock. Do not force the safety lock to open the handle when the safety rope is under stress. Do not hold the safety lock opening handle in the open position.
14. When spraying or cleaning with corrosive liquid, anti-pollution protection measures shall be taken for the hoist, safety lock and electrical control cabinet of the working platform.
15. When parallel movement of the cantilever structure, the hanging platform should be lowered to the ground and the wire rope should be relaxed.
16. When electric welding is carried out in the platform, protective measures should be taken for the platform equipment, wire rope and cable. The welding machine shall not be placed in the platform. The welding pliers shall not be hung on it.
17. Appropriate safety and technical measures shall be taken when the platform is used under such adverse climatic and environmental conditions as high temperature and humidity.
18. In case of rain, snow, fog, sand, wind above level 5 and other bad weather during the construction, the operation should be stopped, and the hanging platform should be parked on the ground. The rope and cable should be bound and fixed.
19. When the equipment failure and safety hidden danger of the hanging platform are found in the construction, the operation must be stopped and the maintenance should be carried out by professionals. After the maintenance, the suspended working platform should be inspected and qualified before use.
20. The suspension platform is not allowed to stay in mid-air after work, and the working platform should be placed on the ground. Personnel should cut off the main power supply after leaving the platform, carrying out the maintenance or finishing work every day, and put the switches in the electrical cabinet in the disconnected position and add the lock.