Generator usage scenario is widespread, using the method is simple, especially suitable for family or small service firms, such as small supermarket, hotel, etc., in addition to the daily normal use, generators and the need for daily maintenance and to ensure the good running environment as far as possible, the following red keda generating set manufacturer to introduce from six directions issued by motor maintenance use.
1. Grinding: namely run-in
This is the foundation that extends service life, no matter be new car or the engine after overhaul, must undertake according to the regulation running-in, just can put into normal operation.
2.Net: that is, clean oil, clean water, clean air and machine net
Diesel and gasoline are the main fuel of the engine. If diesel and gasoline are not pure, they will make the precise fit body wear and increase the fit gap, resulting in oil leakage, drop of oil, reducing the oil supply pressure, the gap becomes larger, and even cause the oil road blockage, axle burning tile and other serious faults. If there is a lot of dust in the air, it will accelerate the wear of cylinder liner, piston and piston ring. If the cooling water is not pure, will make the cooling system scale blocked, hinder the engine heat dissipation, lubrication conditions are poor, the body wear serious. If the surface of the machine is not clean, the surface will be corroded, shorten the service life.
3.Foot: namely oil foot, water foot, air foot
When the supply of diesel, gasoline and air is not timely or interrupted, there will be difficulties in starting, poor combustion, power decline, the engine cannot operate normally and other phenomena. If the oil supply is insufficient or interrupted, the engine lubrication will be poor, serious body wear and even burning tile phenomenon. If the cooling water is insufficient, the machine temperature will be too high, power decline, wear and tear, reduce the service life.
4. Inspection: check the fastening part frequently
Due to the impact of vibration and uneven load on diesel engines and gasoline engines, bolts and nuts are easy to become loose. Still have the adjustment bolt of each place should check, lest cause the accident that damages airframe because of looseness.
5.Adjust: that is, the diesel engine or gasoline engine valve clearance, valve phase, fuel supply advance Angle, injection pressure and ignition timing should be timely checked and adjusted, to ensure that the engine is often in a good technical state, in order to save fuel, to extend the service life.
6.Use: that is, the correct use of the engine
Before use, the bearing bush and other lubrication parts should be lubricated. After starting, it should be put into operation when the water temperature reaches 40℃-50℃. Long time overload or low speed operation is strictly prohibited. Before shutdown, the load should be removed to reduce the speed. After winter parking should be water temperature dropped to 40 ℃ to 50 ℃, have put a net cooling water except engine dozen of antifreeze. Usually to do a good job of engine maintenance work, make the machine always maintain in a good state of operation. To frequent observation, frequent inspection, found fault, timely elimination.