Brand：	none
Address：	China
Min.Order：	none
Supply：	none
Valid until：	Long Term

Product Details

Gledopto PRO 25/120 Degree ZigBee Gateways GU10 Coloured Led Spotlights RGBW RGBCCT Spot Light

Product Description

How to use

Installation & 2.4G RF Remote Control Operation

1.Turn off the Power.
2.Plug in the bulb.
3.Now you can connect it with the gateway.

Connection with Gateway:
1.Start the device searching on the ZigBee Light Link Gateway, it could take some time.
If the Gateway does not find the device, switch off/on the gateway and try again or
3.The Gateway found your device and you can assign it to the different rooms/zones/groups.
4.Now you can use the device.

Reset
1.Switch on your device.
2.Now switch off and on within 2 seconds.
3.Repeat off/on four times.
4.Reset is done when the device is switched on in the fifth time and the light stays on after blinking 4 times.

Link & unlink with 2.4GHZ RF Remote Control

*How to Link

1. Within 3 seconds after power on, click the "on" button of the group to conduct code matching, and the LED lights
turns green, indicating successful code matching.
2. Long press the "off" button of the remote control to enter the night light mode, and the brightness and color can still be
adjusted at this time.
3. Long press the small moon key to enter the 60 seconds delay shutdown state.
4. Long press M key to enter automatic mode.

* How to unlink
1. If the LED is still connected to the ZigBee gateway, long press the "on" button on the remote control within 3 seconds after
power on or press the button for 5 times continuously, the light will flash for 5 times in the current color.
2. If the LED is not connected to the ZigBee gateway status, lon gpress the "on" button on the remote control within 3 seconds
after power on or press the button for 5 times continuously, then the LED light will be fully bright and flashing for 5 times.

Different Lighting Modes Description

*Mode 1: Static warm white color (warm white color only)

*Mode 2: Static white color (cold and warm white color are equally bright)
*Mode 3: Static cold white color (cold white color only)
*Mode 4: Static red color
*Mode 5: Static green color
*Mode 6: Static blue color
*Mode 7: RGB fade in and out (from red --> green --> blue --> red, and so on, speed adjustable)
*Mode 8: RGB flashing (from red --> green --> blue --> red, and so on, speed adjustable)
*Mode 9: Color breathing (On this mode, the brightness of current color will cycle from 100% to 0%, then from 0% to 100%. At the same time, you can switch the color and have a cycle repeatedly. Pressing switch/mode button to exit this mode)

Packing & Delivery