Product Description

Fire Protection UV IR Flame Detector

Introduction:

AW-CFP2166 series conventional fire alarm panel is designed based on EN54 part 2&4 standard.
It is modularized design, the panel can extend from 1 zone to 32 zones easily.
It has 2 level control mode by a lock
It has 24VDC and 5VDC power supply output.
It has FIRE and FAULT signal output.
It has 2 general sounders output.
Each zone has 1 circuit detectors input .
Each zone can be disable by a button.
It has RESET button to reset the panel.
It has SILENCE button to stop BUZZER and SOUNDERS.
It has EVACUATE button to start a manual fire alarm immediately.
It has battery low protection function, when battery voltage lower than 21VDC, battery will be cut off automatically until the mains power is on.
It has an optional GSM module for fire alarm by SMS

Parameters:

Operating Voltage Range	12 to 30 VDC Volts
Standby Current	≤10 mA @ 24 VDC
Alarm Current	≤30 mA @ 24 VDC
Spectrum	180~290nm
Detection Angle	110 degree
Detection Sensitivity with 2Kg ethanol )	Grade I, 25m flame (Container 33cmX33cm,Height 5cm
Relay Contact Load	1A,DC24V
Normal Status	LED blinking in 5 seconds interval
Alarm Status	LED lit steady
Protection rating	IP 32
Operating Humidity Range	10% to 93% Relative Humidity, Non-condensing
Operating Temperature Range	-10°C to 50°C (14°F to 122°F)
Height	1.8"(45 mm) installed in Base
Diameter	4.0"(103 mm)
Weight	5.4 oz. (153g)