Features of 1200mA*1CH DALI Driver DL8009:

1.PWM output constant current:1200mA/CH and 1 channel output.
2.DALI digital control input, dimming control LED module.
3.Addressing output channel.
4.Dimming range is from 0-100% range, (LED brightness start in 1%).
5.Used for DC power supply, over-temperature protection, safety level is 2.
6.Support TOUCH DIM function and can be dimmed manually.(220VAC dimming way)
7.Two channels DC12-48V constant voltage output.

Parameters of 1200mA*1CH DALI Driver DL8009:

Touch Dim Function Description:

1).Short press the Touch DIM switch(<0.5s)to control the lamp on or off.
2).Long press the Touch DIM switch(>0.5s)to dim the brightness of light;The dimming direction will change every time after pressing switch.
3).When the light being turned off,long press the Touch DIM switch can turn on the light and adjust the brightness according to the dimming direction.
4).The brightness adjustment range is 1%-100%, and the light can be turned off through short pressing when do the adjustment with long pressing Touch DIM switch.
5).Power off memory function,the state before turn down will be maintained when power on again. Product Installation Notes:

1, Please read the connecting instruction picture before installation.

2, Please use the complete set of product according to the provided specification.

3, Please firstly pressure the cap end down in wire connecting process,then insert the thread of wire,and lastly check the wire is or not insert firmly.

4, In order to avoid the damage of the equipment,please check the connecting method is correct or not before connecting the power.

5, Please ensure that the grounding end "" well reliable grounding.

6, The DALI bus is using BV 2 x1. 5 mm wire, the longest distance is 300 meters.

Remark:DALI and Touch DIM Functions can’t be used simultaneously,which can be controlled respectively by using DALI controllers or equipments with Touch DIM Function.

Touch Dim Wiring Diagram:

NOTE: DALI signal and Touch DIM can’t input together.

Note:

1. Use of switching power supply power on before, please check whether the input and output lines connect to (alternating current (ac) line of fire, zero line, the grounding wire, dc voltage positive and negative), suggest using wire sectional area more than 0.75 mm copper wire; In order to ensure the safety of using and reduce interference, please ensure that grounding end is good reliable grounding.

2.When dimming, the output end has the LED light indicator.